RC10Talk - The Net's Largest Vintage R/C Community

I'll use a drum or a stone to clean up a badly cut areas or for curves that are too tight for curved scissors.

That's a pretty close finish between 1 - 3

I'm glad it went to good hands and kym has done a much better job restoring it than I could have.

ESC installed, and put the white wing on. The pink one is with my body painter so as he can match the paint. https://tcphotos.net/images/2024/04/13/IMG_8104.jpeg https://tcphotos.net/images/2024/04/13/IMG_8105.jpeg Dont know if I pasted this, but the stack of header cards show how many parts I had ...

I've been using Acer turnbuckles

The expression on your neighbours face when they come over would be priceless

Great build. Could you post your settings of the turnbuckles and toe links please Thanks, not too much adjustment on these but this is what I ran. The steering rack is a standard Factory Works steering rack, all I did was shim it to eliminate bump steer. I didn't get a chance to try shorter links w...

Another piece of the puzzle, incognito black steering set from Factory Works. I'm struggling to find someone who has 2.5mm black G10 here. Ebay has G10 sheets but they are all 300mm and I need 330mm

And number 20... weird

romulus22 wrote: ↑Tue Apr 09, 2024 7:02 pm A little long, but has all the tuning info you should need in here. I’ve watched this way too many times too admit.

https://m.youtube.com/watch?v=OJ29UqE0uS0&pp=ygUNcmMxMGd0IHR1bmluZw%3D%3D

That's a classic

It's one you need to have a hard copy of.

Team Moo 20240409_184130.jpg TeamMoo.JPG Is that 2nd pic your truck, or a magazine pic of the original Team Moo RC10GT? Gravel is the same as the top pic, Knowing RJ that’s definitely his truck, has definitely dropped a bomb with this one, glad my next build isn’t finished, no chance against this b...

morrisey0 wrote: ↑Mon Apr 08, 2024 6:12 pm8675309

Team Moo

Wind the big silver needle all the way down till it's just snug, then back it off 2.5 turns The needle that the throttle arm is attached to set that flush. Set the idle speed screw so there is about 1mm gap in the carb. ________________________________________________________________________________...

Metal parts like the motor plate won't thread unless you re-tapped them to 3mm. The upper shock mounts and steel balls in the shock ends won't fit 3mm unless you change them, and any through hole will be tight and need to be opened up.

What do they offer for the 5-40 threaded screws? 4mm?