i dont know what im doing so is some one help it will be really helpful

would this work on my hpi nitro t 15 star engine

http://www.ebay.com/itm/Savage-X-4-6-CL ... 564a36d7e6

thanks for the help

I'm thinkin not gonna work. It might but I know the collet is going to be too big for your t 15. The flywheel nut is too big also and not knowing which shaft you have on your t15. The shaft on that 4.6 is alot bigger than the one on your t 15. What are you putting this t15 in again? Got some pix of the new motor and will figure out what will work for it...

Todd

thanks here the pics

You might be safe with the MT2 parts. I can take a measurement for you from my truck if it would help. Just let me know specifically where and what your concern is on actual size. Take a look on the bottom of the engine...I believe it actually has four holes already. Double-check before getting a motor mount.

Here is a link to the manual for the HPI MT2 that comes with the same engine: http://www.hpiracing.com/manuals/pdf/10401.pdf

Yep, winger already beat me to it. Might do a little digging to find some of my old kyosho clutch assy.s. Might have one or two left after parting out the last few basketcases that came and went...

Todd