I just bought this car. I wanted to locate a manual for it but not sure what it is. It looks like Kyosho Burns but the onroad tires made me second guess. Did they make an on road version? Thanks for any help.
I am kind of new to R/C cars. I am mostly an airplane guy. I didn't know all these parts were interchangeable. I will get some better pics and post them to figure out what the shocks are. I appreciate the help.
Dennis is correct, Burns with Inferno parts, radio plate seems like PO used studded standoffs. Picture of the bottom of chassis will confirmed it as for the wheels those are aftermarket Duratrax on road wheels made for the Burns or inferno w/ 19 mm hex. I have set missing one front wheel.
Dear all, I have taken possesion of the remains of what I believe to be a Kyosho Assault. It came with some mounting plates which I don't recognise from pictures of complete Assaults. Any ideas welcome, cheers.
I was wondering if anyone knew what this car is. The tires and differential/axle are from my 12LW just to get it on wheels.
For the life of me, I haven't been able to find any information about this car.
Last post
Hrrm? I'm going to post ics in the thread I've got started. But; as I'm finding out as this progresses, they might even be parts i thought they were or are. With help I know they are not Bolink. But; after finding good era pics of Associated, I not...
Hey im new to this site although i have owned an RC10 for quite a few years.
Ive always been led to believe that its an RC10 worlds car but as i bought it second hand its hard to tell.
Ive been searching this forum for clues, and from what i can...
Last post
Any know where i can get hold of a worlds car bodyshell? if anyone still makes them?
Also some new wheels and tyres?
I purchased a used Tamiya Blackfoot many years ago and it ended up boxed up in the attic as it was when I got it. I have started to clean it up and repair/replace parts in effort to run it again. The truck had these green shocks installed in the...
Last post
Thanks! I was not aware Trinity made/sold shocks and it looks like this was happening while I was actively racing. From what I found on the dirt-burners site they were color coded for application and the green ones are for the Blackfoot.
Is there a chart on how to id the RC10 pan body? I also am looking to id an RC10L. I am hoping for some help. I have seen references to B and A bodies. Where and how do you identify? Thank you.
Picked this up from local guy he bought it new years ago he is looking for the box still.Not sure what it is.It has a (A)stamp on it but he says he bought the truck conversion for it that is what the tires and body mount are in the picture.Can...
Last post
Yep, lookin to me like you might need some front axles and remove those rear wheel adaptors and a body. Should be just about everything for a nice lookin rc10 but I'm sure I'm missing something...