You remove the plastic outdrives from the trans and replace with the metal ones. Them remount the placstic out drives on the dog bone and use the stock axles and cross pin.
I have a TRX 1 that I intend to run through the winter here in the UK.
What I would like is a good base starting point : ie
Shocks, what pistons front and rear
what wt oils and springs, although the spings I have are not coloured
what length shock...
Last post
I was in the lead for an auction on a descent TRX1 this week, but 1 day before it ended the auction got pulled by ebay :| Don't know the reason it as pulled, so better look at it positively; maybe they saved me from a scammer :P
I recently received a Traxxas project car and I had questions about the differences / similarities between the TRX-1, TRX-3 & Blue Eagle transmissions. Based on pictures I've seen, the trans that's currently in the car is from a blue...
Last post
The TRX-1 case has 'TRX' molded into it on the side opposite the motor plate whereas the TRX-3 case does not.
The TRX-3 trans also has a slightly lower CG due to the diff gear being closer to the chassis. I mean literaly you can almost see it...
Are the MIP shiny cvd bones the same as the regular bones except for the finish or is there supposed to be a performance advantage?
Last post
There is the standard shiny ones, which I believe is nothing more than the finish. Then there is the shiny aluminum ones, which are obviously different.
Need some guidance. I have my vintage RC10 complete with MIP SP1 transmission along with the MIP CVDs. However, on the spur side I keep having the dog bone popping out. I have had to restrict the shock travel length in the rear to prevent...
Last post
Keep in mind the early Mip SP-4 outdrives for the SP-3 diff were short, and the later version SP-4 for the Pro & Plus diffs were a tad longer. The late version still fits the SP-3.
Hello.
I have been running my gold pan in our 2wd buggy class this year. I have been doing pretty good with it (usually top 5) believe it or not. I am using a full gold chassis ,stealth trans, b2 cvds modern tires
with Mark W setup from here-
I...
Last post
HELLO aLL THIS IS YOUR OLD PORTLAND RUSTBUCKET . It has been a wile since I have been on the board. I see there is a set up post. OK maybe some of you can help me again like you have allways done.
Can some one tell me how to set up a stock gold...
Been on a mission to resurrect the old JRX2 and here's what I'm going to run...not ready to go brushless yet because I'm not ready to spend the money...already sunk way more into this project than I planned!
18x5 brushed motor
Losi LRM tranny...
Last post
lipo with 27t stock will be enough, even with 18x5 your still fine with your set up
Hello everyone. I recently have gone back to indoor off-road racing this winter after a 7-8 year absence. I'm currently running a 4 wheel drive buggy but I took my old trusty T4 off the shelf and want to put it back in action. My questions are :...
Last post
HOWEVER, I added a bunch of weight to my T5M, and it handled better. I tend to drive heavy vehicles better than light ones. They're too twitchy for me. Sooo, if your RC10T is being twitchy, then it may be a good idea.