Page 1 of 1

Who made Ball Bearing Bellcrank Kits for the RC10?

Posted: Sat May 23, 2009 1:42 am
by msedsp
Want something better than the stcok servo saver in my goldpan and was wondering who (besides associated-have had 0 luck finding any) made ball bearing bellcrank steering kits for the RC10?

Re: Who made Ball Bearing Bellcrank Kits for the RC10?

Posted: Sat May 23, 2009 3:52 am
by Charlie don't surf
RPM, MIP, Houge, Hot Trick, A&L and a few more

Re: Who made Ball Bearing Bellcrank Kits for the RC10?

Posted: Sat May 23, 2009 7:40 am
by aconsola
losi/rps
there are several modern dirt-oval companies which still make bellcranks that are very similar to the originals.

Re: Who made Ball Bearing Bellcrank Kits for the RC10?

Posted: Sat May 23, 2009 1:39 pm
by matteo
Who else is still making them? Which dirt oval guys...need more info. :D

Re: Who made Ball Bearing Bellcrank Kits for the RC10?

Posted: Sat May 23, 2009 4:25 pm
by aconsola
www.kippshobbies.com
(still using old-school frames for html, so no direct link)
products>chassis>kipps first one on top is what you want.
also products>chassis>putnam these are more expensive, and the standoffs are separate(I think they come in different heights?)

Re: Who made Ball Bearing Bellcrank Kits for the RC10?

Posted: Sat May 23, 2009 10:49 pm
by Charlie don't surf
Standoff height is determined by placing the "hex" portion of the aluminum on the top or bottom
of the bellcrank, and the Putnam ones won't work on a older car because they have a fore/aft
hole system for ackerman & bump steer that will connect with the rc10 front bulkhead when turned