Thanks fellas! You are right Rod about the sunlight making the green look in pics like it does in person. Can't wait to find the time to get this one started.
Still debating whether or not to sand/polish all the edges of the chassis/nose plate/motor plate.
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas Factory Works website
They upped the limit here to around 3mb, so if you can get them to fit- try to use the server. That way they will be here as long as the site is up
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas Factory Works website
A guy at my local track has a dirt oval car and he doesnt know what it is, it has a stealth tranny but that is about all we can figure out.
Last post
Actually, many of the parts are no longer available directly from Team Cobra.
Tell your friend to check out because they seem to have a load of Cobra parts still available. They even still sell NIB Nemesis kits. I ordered some Cobra rear arm...
Hey guys....I have some stuff in the B/S/T section, one lot of parts is a dirt oval conversion for the yokomo 870c, that I bought as part of a lot of stuff.(missing wheels though)
the car came partially assembled(or disassembled), and had a photo...
Last post
there's a nip jg 870c oval conversion chassis kit waiting for me somewhere in new york. well, there used to be. it's been so long since he set it aside for me, it's probably gone by now. i forgot all about it until you posted your parts in the bst....
I finally found a new body for my old oval car and it has sparked my interest again, my car is quite unusual. RC10 based dirt oval cars vary wildly and tend to be scattered on the board so why not start a picture thread of different cars, ideas and...
Last post
Came across this guy. Is this a McAllister conversion?
Also has quite a few Andy's parts as well.
382DC00E-DCA5-446B-8491-DA59FC32D57C.jpeg 50FC9EFE-0C06-4362-BF9D-C272E469498E.jpeg 30601915-3351-4C9E-BC80-7C5D95311162.jpeg F5B2EFD3-9AF3-491B-BE4E-869100C4800C.jpeg 98195991-E654-4F73-8EDA-5FAE4C67217E.jpeg
Finally had the chance to check this...
Last post
RPM didn't have a truck bulkhead that accepted nose tubes. The one you have is it, so ultra molded or carbon chassis is about it.
Okay, I see. I prefer to stay away from facebook; not a fan. When I get some time, I'll post some pictures of Jim's old Dominator. It's unchanged since I bought it so maybe he will recognize it.
Im sure the dementions will depend on this or that. The only thing I know is we will mostly be running 1/8 and 1/10 whatever . Maybe just tell me about the largest and smallest youve been to and which you like for running what. Heck, whatever you...
Just wanted to share a few pics of this modified dirt oval modified before I stripped it for resale. I'm not sure about the chassis. Maybe an old sportworks. The whole front end is RC-10. Also has a Stealth transmission with Liesink motor plate and...
Last post
That poor Equalizer. :(
I searched for years to find on in good shape until Phin found me one. I just don't understand why some people did those mods back then. :?: