Project RC10 - LCG

[Headling]

The servo is a Savox 1251 low profile

[RS Chris]

Cool, thanks for the info. Just scored a graphite RC10 and that would work great with it.

[Headling]

Gearbox is in!

[Headling]

Rear tower and shocks mounted up, Test fitted the motor and lipo, not far away now!

[Headling]

Waterfall brace is in and shorty installed using Yokomo bmax 3 cradle and B44 posts

[DennisM]

[Headling]

Esc is in and tapped out the b44 battery posts to m3 and put on the B5 thumb screws

[Chewbacca]

Really nice build

[Headling]

Thanks for the nice comments guys

Well its ready to hit the track!! I will take my go pro and get some footage and post it up shortly

[yellowdatsun]

Need to make a fake VW engine to take up the space at the back.

[alien3t]

Need to make a fake VW engine to take up the space at the back.

http://www.shapeways.com/product/FU7LEU9CD/1-10scale-vw-engine?optionId=40503743

http://www.shapeways.com/product/F4H3LTFGD/ff10001-flat-4-engine-part-1-of-2?optionId=57894701&li=user-profile

[Headling]

Yes agree I needs something to fill the gap at the back of the chassis!

Track test today!!

[Headling]

Guys need some help, with the yz2 box in the car using b44 drive shafts they are 2-3mm too long causing the driveshaft to hit the inner part of the outdrive and not giving me full suspension travel

Any ideas on how I can overcome this issue?? Is there any arms that are a little longer than the stock worlds arms??

Is there a different drive shaft that's shorter than the 44 one??

[jwscab]

are they the b44 front driveshafts?

it looks like you are using b4 rear hubs and stock arms and mounts, is that correct? Look into Niki's shapeways store for his quadra arms and also some different arm mounts. I think he's got something that might work. You might end up with the quadra arms and stock hub carriers or some kinda combination like that.

[Bubbleboy]

How long are the dogbones you are using now? In mm.