Love all your work. My only suggestion is to remove the small 3 colored pieces of shrink tube on the motor wires. Looks so much cleaner without them IMHO. A careful slice with the xacto knife will do the trick.
This is a build for a customer, I'm still finishing it. I have to say, as much as I hate Carbon Fiber, it sure looks nice!
Last post
Hey, that's right! I found a good photo online that has very little perspective, laid my six-hole directly on my laptop screen over the photo and resized the photo until their sizes match and the holes you mentioned line-up perfectly. Now, I can...
Hey Nomad, did you drill the chassis yet? I have a set of 180* Delrin bellcranks that i just cut out, I’ll send you a pair if you want to try them since you already have the posts, rack and bearings. Just let me know.
I got the bellcranks from...
Last post
That seems like a good method. Your eyeball must be calibrated 'cause you appear to have nailed the shock cutout perfectly. Well done Nomad!! :D
I couldn't pass up one of these new Factory Works chassis kits. It is very similar to the ultra rare vintage Composite Craft Worlds RC10T chassis, however it uses the stock aluminum front end. The material finish is very similar to the original, and...
I've wanted a tube caged RC10 since joining the forum. What would be a cool platform? Trailing Arm, semi-vintage from Factory Works! I already had some of the components to get started, that made the choice pretty easy. Here's a couple of pics to...
Last post
Looks nice, Nomad. Yes, that wing will be tricky to mount but I have confidence you'll find a clever solution.
Well done!! :D
Thank you, brother :D
I have a brain spurt about it, came about at lunch today. a pivot with position locking screws...
The C2.1 isn’t for everyone. While they have a wild styling, they also have very little room for electronics. Their curves don’t suit everyone. I wanted to offer a variation with different styling, thus the C2.2
This one was built as a truck (using...
Last post
I'm digging it, there's room for it at my place!
Edit: I posted by mobile in a can't sleep mode . Could I get some detail pics of where the trailing arms attach to the chassis plate? Please :D
Well, the C2 chassis was due for an update. The 2.1 versions have a narrowed chassis and are braced for rigidity. They are now drilled for the Lethal Weapon and 6 gear, and can be special ordered for stealth. The truck version requires A&L or Worlds...
Last post
Cool, thanks Jeff. I think I'll slow down a bit... get my s**t together :mrgreen:
I ordered that aftermarket nose plate this morning. I'll get with you for a buggy version after the holidays :wink:
I just got my RC10GT partially reassembled, and discovered that the steering is worse than useless. I want to get a Factory Works ball bearing steering kit for it, but am utterly lost as to what these 3 drag link options are. Is there any...
Last post
Thanks for the help! I didnt realize you were factory works.
Here we have some pics of my C2.1 that I have been slowly getting together. It has custom parts made by myself, GoMachV, and lots of AVID parts. I'm trying to stick with a black and silver them. Lots of stainless steel hardware and Factory Works...