you'll find that you'll be rebuilding these cvd's now because they are wearing out instead of the pin falling out. For what its worth I've had a set of cvd's I did this too in a gt of mine for years without any issues. I've rebuild them due to slop a couple of times but no falling apart anymore. And for the $ and time its a well worth hopup even if you aren't having any problems.
Todd
Peace and professionlism.....Kabunga signing off!!!
I know i have read on here about people doing this but i have tried and have tried just about every dogbone i can find and cant seem to find one long enough i have a rc10 graphite im turning into a racer and i want to make the rear as wide as...
Last post
thunder tiger bx buggy rims are the same as b3 rims.
I recently acquired a t2 and one of the rear arm mounts is broken. There was a thread about these somewhere in the forum, but the last post was a while ago and they seemed to be rare then. Any ideas where to start searching? Thanks in advance!
Hi, I see a lot of nice rc10 in this forum. I'm new to the vintage hobby and would like to know if changing the rear axle to B4 is the only changes I need for using the wheel that we normally see at hobby shop now? Do I need to change the carrier...
Last post
Welcome,
You will be doing a lit of reading, then decide if you will be changing the axle to 3/16 to fit modern B4 rims or just need an adapter or rims from ebay.
Can anyone tell me if the rear carrier\axle bearings are still available from associated in the stock gold pan size? What are the measurements? MIP still makes cvd's for the stock length arms(i think) so I'm going to grab a set and would like to...
I just found my old RC10LSS pan car and found that the rear axle(associated part#8210) is broken,and cant seem to find one.ANYWHERE. Does anyone know of a comparable replacement? Any help would be greatly appreciated.
Last post
10L and 10LSS are different axles. The eBay axle was for a SS, same as some 1/12 axles. It will be way too short for a 10L
yeah, I had my hopes up. :)
I had no idea how many versions of the 10L there were.
I recently bought a vintage gold pan with 6 gear transmission. I was wondering if someone could refresh my memory and tell me what the size of the axles are on these. Does anyone know if the modern wheels will fit with the truck conversion adapters...
Use Shoe Goo to keep your axle pins in place...DO NOT EXPAND THE ENDS BECAUSE YOU ARE AFRAID THEY WILL FALL OUT !!!! Then the next person who you give the car to or sell the car to has to resort to medieval tactics to get them suckers...
Last post
Longboard: what's wrong with the rollpins? Did you shear them?
yes alot. i run the rtr b4,t4,sc10 dogbone rear axles(or the same size cvd setup on some of my cars) on alot of my rc10s . if your talking about the larger tapered axles the stock pins...