Page 1 of 1

Is there a 3S lipo that fits nice in the rc10 worlds re re?

Posted: Mon Sep 11, 2017 6:48 pm
by Showcase1186
Thanks for your help in advance. I've done a search on here with limited luck on here. Is there a 3S lipo that will fit the rc10 worlds car re release without hacking up the battery cups?

Thanks for any help!!!

Re: Is there a 3S lipo that fits nice in the rc10 worlds re re?

Posted: Tue Sep 12, 2017 7:29 am
by yellowdatsun
The reason you aren't finding any info on it, is that nobody does it. A 2s hi-C rating pack with a fast motor is WAY more than enough for these cars. A 3s system would grenade the tranny in short order.

In addition, they won't fit in the stock battery cups anyways. Maybe length and width if you're lucky, but not height.

Re: Is there a 3S lipo that fits nice in the rc10 worlds re re?

Posted: Tue Sep 12, 2017 10:16 am
by Showcase1186
What are you running that fits well in 2s

Re: Is there a 3S lipo that fits nice in the rc10 worlds re re?

Posted: Tue Sep 12, 2017 2:16 pm
by Lonestar
Any standard 2S pack... this is what the re-re worlds was designed around ;)

Re: Is there a 3S lipo that fits nice in the rc10 worlds re re?

Posted: Mon May 13, 2019 11:10 pm
by rcnewbie
A standard 2s lipo battery pack with deans plug can fit, such as a ovonic 2s 5000mah lipo.

Re: Is there a 3S lipo that fits nice in the rc10 worlds re re?

Posted: Tue May 14, 2019 3:10 am
by broodenburg
A soft shell 3S pack will fit. But I agree with yellowdatsun that this is way too much power. I run 3S with a 8.5 in my T3 every now and then and that's TOTALLY overpowered.

Re: Is there a 3S lipo that fits nice in the rc10 worlds re re?

Posted: Tue May 21, 2019 12:58 am
by discgolfer72
not certain on the buggy , but I run a venom 3s 4000 shorty lipo in a late black parts rc10t . should fit fine in the buggy also
running a dynamite 4900 kv brushless , and the trans is holding out fine . I do keep ripping out the insides of my rear wheels , and tires last 2 runs

Re: Is there a 3S lipo that fits nice in the rc10 worlds re re?

Posted: Fri May 24, 2019 8:10 pm
by DaveM
2 cell = Fun :D

3 cell = Broken Parts :(

Re: Is there a 3S lipo that fits nice in the rc10 worlds re re?

Posted: Thu Aug 01, 2019 8:08 am
by Dadio
At the very least your gunna need about 2lbs weight on the front end to stop it lifting the front wheels ! , a good 2s hight C rating race pack is plenty , if you want to go nuts stick a 7.5t or 6.5t brushless motor in it and that's probably still overkill .