Page 1 of 1
MIP 4X Chassis instructions- Who can read this?
Posted: Mon Jan 07, 2019 8:18 pm
by Meakz1973
Hi Guys,
I'm wondering if anyone can read the full line of text next to #1 under assembly please?
'1. Use square spacer under.......xxxxxxxxxxxxxxxxxxxxxxxxxxxx...down with #4 7/16 screws'
I'm trying to figure out what to do with the spacers in my MIP4x400 SRB build.
Thanks to anyone with eagle eyes or a clearer copy of these assembly instructions!
Re: MIP 4X Chassis instructions- Who can read this?
Posted: Mon Jan 07, 2019 11:18 pm
by a01butal
Use square spacers under (maybe) camber ####### ########## ######## with #4 x 7/16 screws. Sorry that's all I could make out.
Re: MIP 4X Chassis instructions- Who can read this?
Posted: Tue Jan 08, 2019 12:57 pm
by Meakz1973
yeah, that word could be camber... thanks... 1 down 2 to go!
I can't find a scan of these instructions anywhere on the web. The photo I attached was from a yahoo auction
Re: MIP 4X Chassis instructions- Who can read this?
Posted: Tue Jan 08, 2019 8:35 pm
by a01butal
I actually owned this kit and sold it a number of years ago, I think I know who bought it but not sure I can contact him. Sorry I never opened the package so never looked at the instruction sheet.
Re: MIP 4X Chassis instructions- Who can read this?
Posted: Wed Jan 09, 2019 5:35 pm
by transamman908
I have a clear instruction sheet. "Use square spacers under camber mounts bolted down with #4x7/16 screws"
Re: MIP 4X Chassis instructions- Who can read this?
Posted: Thu Jan 10, 2019 2:07 am
by Meakz1973
Nice! Thanks for the help, I appreciate the responses.
My next question is what/where exactly are the camber mounts
Re: MIP 4X Chassis instructions- Who can read this?
Posted: Mon Jan 01, 2024 11:58 pm
by Y'ernat Al
About 1/4 of the way down this page
http://www.toybaron.com/MIPreference.htm there is a red-wheeled color photo (might have been one of Shodog's) that shows that the camber block bar of frp (if that's what it's called) presumably those two little square frp parts as spacers to elevate it off of the chassis? There might be other photos here that help. For SRB's in general (even without the MIP conv) there was a common mod to lower the center of gravity of chassis by putting frp blocks under the tranny/suspension unit and front shock towers. These might be essentially doing that.