Custom 3D Printed Idle Gears for the Raider/Rocky Installed
Posted: Thu Oct 19, 2023 10:58 pm
by Snaab9-2
61 mph wasn't enough (still need to break 100 kph) so I installed a custom 3d printed idle gear (30t idle gear along with a 20t pinion). Once I get my stability issues corrected, it should hit 65+ mph.
If anyone was looking for optional stock 32t idle gear, there is a file for that too!
Re: Custom 3D Printed Idle Gears for the Raider/Rocky Installed
Posted: Fri Oct 20, 2023 3:13 am
by Dadio
Nice video , you'll have to post a running video as well .
Re: Custom 3D Printed Idle Gears for the Raider/Rocky Installed
Posted: Fri Oct 20, 2023 10:02 pm
by Snaab9-2
Dadio wrote: ↑Fri Oct 20, 2023 3:13 am
Nice video , you'll have to post a running video as well .
Thank you! I have one filmed but I need to edit it still (sadly the car sill was not handling well, I think it may actually be because I used to use a cell phone taped to the bottom of the car as a GPS and now that I have a dedicated GPS and as the Raider is so light.... perhaps the front needs weight to get much past 35 mph.
Hopefully I will figure it out next time I take the car out.