RC10Talk - The Net's Largest Vintage R/C Community

Yeah, I have a B2 and 10T in the works as well.

Here is my ‘other’ stadium truck entry for VONATs...an RC10T Team Truck.

My other VONATs stadium truck, I’m going to switch between rounds. It was a standard XXT, but the chassis was more damaged than I liked, so I bought the CR XL chassis. Just upgraded the suspension to CR at that point. Aluminum bones, composite outdrives, Trinity front and trans brace. I’ll dye the n...

A Hydra-drive rebuild kit replaces everything except the housing and bearing inside. Pretty much a straight disassemble, replace parts and reassemble procedure.

Lol, the whole reason to convert to hexes was the lack of availability of the original pin wheels. Now that pin wheels are re-released...

As a guy that restores my own esc's... Here's the issue, no one wants to be responsible for your old, used, rare equipment. Do the speed controls work 100% functionally to begin with? I've bought speed controls where the seller says they work (because they plugged it in and it lit up) and they don't...

It's all RC10T. There are just a couple of mixed early/late generation parts on it. You have a nice truck.

I have a set of used wheels for your truck. I also wouldn't mind getting that Yellow #4 FM receiver crystal from that AM receiver.

Contact Jerry Hellström on the Facebook group RC10 Vintage Mania for help and advise, he's been working on making carbon fiber chassis's too.

You'll probably need an Airtronics crystal in the receiver, and a Futaba transmitter crystal in the transmitter - on the same band/frequency. If memory serves...one is positive shift, and the other is negative shift (don't remember which). But it's a matter of the crystal actually functioning in the...

RC10T standard kit parts are... 4.5 degrees total rear toe-in per side. 6360 1.5 degree rear arm mount 7358 3 degree rear hubs What Chris's setup says... 3 degrees total rear toe-in per side. 7363 3 degree rear arm mount 7365 0 degree rear hubs But...Pictures of the rear end and top view show 3 degr...

RC10T setup option part list

#4187 .030 nylon washer the part your looking for?

Contact BSR racing for 1/10th pan car tire foam...

http://www.bsrjaco.com/10th-pan-car

Looks original. Open it up and pull out the armature and post some pics of that too.

Older MTM, 19x2. Team Losi/Japan on can, just positive symbol and no brush hood heat sink.