RC10Talk - The Net's Largest Vintage R/C Community

I've putting together an all-in-one kit for those that want to get their boxart rere Kinwald cars a little closer to the original, or for those who are looking to make a correct replica. The kit will contain:

1 - Front shock tower in 2.5mm 3k woven cf
1 - Rear shock tower in 2.5mm quasi uni-iridium matte carbon
1 - Stealth trans brace in 2.5mm 3k woven cf
1 - Battery brace in 1/16" matte black fiberglass
12 - Stainless Steel flat head screws for towers and trans brace

I have 1 blem trans brace. It'll work and all, but it has a bit of delamination around one of the countersunk holes (front right outside corner). This kit I'm discounting $7.00.

$50.00 shipped....................... SOLD OUT
$43.00 shipped (blem).............. SOLD OUT

*** Pictures Added ***

Part #103

OK, here is the blem on the trans brace. There is a spot similar on the back left hole too, but I can't get the damn pic to load.

Have a couple more sets of these back in stock for anyone that is interested.

Still have a kit with a blem trans brace at a reduced cost too.

Are you going to do anymore of these kits Jason?

I kinda doubt it. Too high of a material cost and I doubt the demand is there to make it worthwhile.