YZ10 Protech body question for experts
Posted: Tue Feb 13, 2018 1:01 pm
Hey guys,
Just did another run of Protech bodies and ran into same issue had at other location. There is a line that forms in front of the windshield on nose. I discovered the reproduction MRLEXAN mold is most likely in need of some modifications. It either has an error when it was cast or needs some work to make it perform better.
Please check out this video to see the issue I have.
https://youtu.be/Mng5XII9_Gw?t=47
If you watched it, do you know how the original should be? Is there a dip in front of windshield. Looking online it is to hard to tell. Need someone who can look at an original.
I am guessing that small dip shouldn't be there. It probably should be a nice gentle curve to meet the flat nose. But I am only guessing.
Thanks,
Dan
Just did another run of Protech bodies and ran into same issue had at other location. There is a line that forms in front of the windshield on nose. I discovered the reproduction MRLEXAN mold is most likely in need of some modifications. It either has an error when it was cast or needs some work to make it perform better.
Please check out this video to see the issue I have.
https://youtu.be/Mng5XII9_Gw?t=47
If you watched it, do you know how the original should be? Is there a dip in front of windshield. Looking online it is to hard to tell. Need someone who can look at an original.
I am guessing that small dip shouldn't be there. It probably should be a nice gentle curve to meet the flat nose. But I am only guessing.
Thanks,
Dan