Page 2 of 2

Re: TRX-1 Mods and Parts guide

Posted: Mon May 22, 2017 11:11 pm
by Delorean
Thanks to Klavy69 for adding part numbers to the original post etc, just added badnats slider driveshaft replacement using integy bandit hardware

Re: TRX-1 Mods and Parts guide

Posted: Mon May 22, 2017 11:17 pm
by klavy69
your welcome. Anytime I can try to help out I will to keep some love goin on these forgotten traxxas's :wink:

I just read the part number in the other thread and was thinkin of this thread so worked out pretty good.

thanx for the thread 8)

Re: TRX-1 Mods and Parts guide

Posted: Tue May 23, 2017 7:17 am
by Lonestar
Have I mentionned that the AE battery boxes are a direct fit on the chassis with the right hole spacing?

However, beware: the AE battery bar doesn't fit on the TRX box mounts :(

Re: TRX-1 Mods and Parts guide

Posted: Wed Nov 22, 2017 9:37 pm
by TRX-1-3
This is an interesting thread as far as mods/parts


viewtopic.php?f=31&t=30798


Especially:
"RB5 rear CVD's with Kyosho outdrives."

I wonder if these would solve the A&L trailing arm clearances issue? (Around the ID of the inboard bearing bore area of the trailing arm) I guess traxxas universals are too bulky.

Re: TRX-1 Mods and Parts guide

Posted: Thu Nov 23, 2017 12:05 pm
by Mr. ED
viewtopic.php?f=31&t=18468

You may want to have a look at my tcp too

Re: TRX-1 Mods and Parts guide

Posted: Sun Feb 04, 2018 8:44 pm
by JK Racing
This is great....I have my TRX1 that has been begging me to rebuild it. Getting a few A&L goodies then will be digging in! My goal is to get it ready to race and be able to use 12mm hex wheels on all 4 corners. If I cant get the front done easily, then at lease adapt it for my RC10 WC front wheels, I just despise having to carry around all different set of front wheels/tires when I go racing - trying to keep it to 2 kinds, hex or bearing only.