Anyone polish Polished shapeways?

Post by **Minisforever** » Sat Feb 07, 2015 8:33 pm

All the polished shape ways parts I have received in the past months has a sandblast finish to them. Did the shapeways polished parts always have this rough surface to them? What's the easiest way to get them to have a smooth polished surface? I been using sand paper and elbow grease, but there's gotta be an easier way

What's everyone's techniques?

Post by **slotcarrod** » Sun Feb 08, 2015 6:20 pm

Mine too, I thought it was normal and odd for them to call is polished!

Just boiled mine in tea and never bothered to sand but I would imagine fine sand paper would do the trick!

Post by **Diamond Dave** » Mon Feb 09, 2015 11:13 pm

If the part is flat where you want it to be polished, use a whet stone.

Something higher than 800 or 1000 grit to polish it and in a few minutes you will be as smoooooth as Rod's butt!

Post by **slotcarrod** » Tue Feb 10, 2015 2:40 pm

Diamond Dave wrote:If the part is flat where you want it to be polished, use a whet stone.

Something higher than 800 or 1000 grit to polish it and in a few minutes you will be as smoooooth as Rod's butt!

You been peeking in my windows again?

RC10Talk - The Net's Largest Vintage R/C Community