Just ordered 2 of these and I have to say for the price that are awesome. I will be equipping more of my cars with these servos as time goes on and money allows.
Finishing up a partially built 12L4 I snagged on ebay and I planned on putting in a Futaba S3002 metal gear servo. The problem is, the metal spline has really fine threads and a really short screw. The screw is long enough to mount a horn but not a...
Last post
that was a great deal on that L4, I almost bid on it but I want a link car so I can run Lipo. Are you going to come out to Thunder to run it?
Yea, it was thanks. The seller was a little careless and didn't bother to bag the rest of the small...
What's up guys. Been while since I posted. Got back to working on my 10Ts and need some advice on a few ideas. Can anyone offer a good metal gear servo to put in the trucks? And looking to change the gear ratio in the tranny (at least that's what I...
Silly question but i'm getting back into racing after a long break and was trying to source some decent servos for my vintage racing.
Will the new digital servos work with my older Novak NES-2X and vintage Tekin receivers?
I have a collection of NOS...
Last post
I have used newer digital servos with my old AM receivers with no issues. I usually put a large capacitor on the batt plug on the receiver to reduce brown outs since the newer servos draw a bit more voltage than the old analog ones. The cap also...
I have a rtr t4 and i just broke the servo (at the track).. the built in servo saver seemed loose but is that not enough?? Are people runing mini servo savers on the servo too?? any help would be great...
Last post
yeah, just upgrade the servo and not have to worry about it again. That S3305 is over twice the torque of the 1504 that comes in the T4 rtr with similar transit speed. I have one that's been in a spec slash for well over two years now, it usually...
Just resurrecting my XX and it seems my original Futaba S132 has finally given up. Just wondering what current servos are you guys using in your XXs? Thanks.
So do the new metal gear servos no longer require Servo savers?
Last post
I took my time before sending my S6240 Spektrum in for warranty but a mere 3 weeks after sending it in I got it back.
No more rattles!!! Horizon sent me a new servo. I haven't even put the cap back on the receiver yet. Works great.
Hey guys, I'm looking for a good steering servo for a Rc10T3. I have Dirt Hawg II's on the front. Right now I am running a Hpi SF-1 servo out of my savage x and it doesn't move them as fast and strong as I would like. Any suggestions on a servo?...
Last post
Some things to consider like was mentioned is your steering end points. In the old days you simply remove the servo saver and put all radio settings in the middle. Turn the car on and servo would go to its neutral position. Reinstall the servo...