Acoms receivers do I need to change wire position?

Brushed, nicad, radios, etc...

Moderators: scr8p, klavy69

Post Reply
AYKBOBCAT
Approved Member
Posts: 585
Joined: Wed Nov 22, 2006 2:32 pm
Location: Bas St-Laurent, Canada

Acoms receivers do I need to change wire position?

Post by AYKBOBCAT »

Hi

I have 2 Acoms AM receivers (AR-227FE) that I got in a lot of parts. I think they are brand new but when I tried to test them I could not make them work. I only have futaba servos so I think it could be a problem with the wire position on the connector. I don't need those and I'd like to sell them. Do I have to switch the wires around for those receivers? If so what position should be the red, black and white wire then?

Thanks for the help...

User avatar
Incredible_Serious
Approved Member
Posts: 3380
Joined: Tue Jan 29, 2008 12:09 am
Location: Melbourne, Victoria, Australia
Has thanked: 1332 times
Been thanked: 796 times

Re: Acoms receivers do I need to change wire position?

Post by Incredible_Serious »

Acoms should be the same as Futaba, signal-positive-negative. Was usually only older Sanwa and KO stuff that had the negative in the middle.

Alex
Osiris is the key.

"The world looks so much better through beer goggles... except Farmer in his underwear" - Ken

Look out for Todd K. - he's a convicted serial killer!!!

AYKBOBCAT
Approved Member
Posts: 585
Joined: Wed Nov 22, 2006 2:32 pm
Location: Bas St-Laurent, Canada

Re: Acoms receivers do I need to change wire position?

Post by AYKBOBCAT »

Ok thanks

Post Reply

Create an account or sign in to join the discussion

You need to be a member in order to post a reply

Create an account

Not a member? register to join our community
Members can start their own topics & subscribe to topics
It’s free and only takes a minute

Register

Sign in

  • Similar Topics
    Replies
    Views
    Last post
  • acoms arb 227
    by moj » » in Tamiya Forum
    2 Replies
    805 Views
    Last post by moj
  • [Manual] Acoms AP-227 HiRes PDF
    by TomEG » » in Vintage Catalogs / Instruction Manual Scans
    0 Replies
    1127 Views
    Last post by TomEG
  • [Manual] Acoms AP-227 mkII HiRes PDF
    by TomEG » » in Vintage Catalogs / Instruction Manual Scans
    0 Replies
    1191 Views
    Last post by TomEG
  • Battery holder position
    by tjf » » in RC10 Buggy Forum
    5 Replies
    1032 Views
    Last post by vintage AE
  • Buggy steering servo position
    by Rslaback » » in RC10 Buggy Forum
    5 Replies
    554 Views
    Last post by LusBus
  • Front upper turnbuckle mounting position?
    by superfly » » in RC10 Buggy Forum
    14 Replies
    1937 Views
    Last post by superfly
  • Procat Anti Roll bar Position?
    by Jools » » in Schumacher Forum
    1 Replies
    881 Views
    Last post by Danf1275
  • Old Receivers
    by urban hype » » in Vintage Electronics
    3 Replies
    1073 Views
    Last post by urban hype

Return to “Vintage Electronics”

Who is online

Users browsing this forum: No User AvatarGoogle Adsense [Bot] and 11 guests