Yes, direct replacement. They use the longer hingepins though. Rere uses shorter late style pins. Rpm sells them as their arms also require them. Rpm 70590
It's time to stand up to the bully. Support the companies that support the industry, not the ones that tear it down. Say no to Traxxas Factory Works website
The later AE arms for the 10T, GT and T2 have the spacer for adjusting the wheelbase. The early AE white arms and the RPM arms dont. My question is lined up next to each other is Does the RPM arms line up with the short or long position or are they...
so i'm not striving for authenticity... IOW i'm not trying to build a convincing fake. I'm just trying to in a sense, update my original gold pan classic to the latest/best handling parts for it and leave it at that. i've already got a stealth for...
Last post
upper camber link
rear arm mounts
cvd's
rear hubs
things that you are looking to update would be these. the original worlds manual would have all the part numbers necessary to let you know what you need, should be able to download direct from...
I have been working on another project in my spare time, but have a question. I am building up a buggy with Klein rear arms to get some more extension. In my research, I was told to use some B44 rear CVD's. I think that i am using a RC10T...
Last post
What size bearings on the custom wotks hub? I have a few sets coming to use with the b44 cvd.
Just to confirm its 3/16 x 3/8 × 4 bearing size
thanks
Yes, this is the correct size of bearings for CVDs with 3/16 axles.
Why was/is there no aftermarket rear arm available for the b4/b44 besides the stock version and a hard version from AE, I dont want to run aluminum rear arms..........................
Am I missing something??
Jake
Last post
i think mostly the issue back then was the front was the common weak link of the b44 and the rear are not often
braking.i remember GPM has after market for the arms but no RPM rears only RPM fronts.
Hi guys, can you please enlighten me if the B2/B3 rear arms able to fit into the gold tub rear arm mounts? Thousands thanks!!!
Last post
i just used the outermost cr parts, not the arms. car also has the narrow rpm wide arm front. the width is 9.75 which is just under the roar limit of 250mm/9.8425 .
I'm in the process of restoring 1 a chassis rc10 and putting another b chassis runner togeather, while doing so I noticed that the arms for the a chassis are shorter where the hinge pin goes through and it requires a shorter hinge pin, was there a...
Last post
Your short pin white arms are correct for a later RC10 CE - and I think they only came on cars with the Stealth trans.
Your A chassis needs standard long pin white arms (fairly easy to find).
I'm wondering what the story is on Aluminum rear arms for an original rc10? I know I've seen some before, but can't remember where (maybe on some of the older bart's sprinter's?). Anyway, I'm looking for some for a shelf queen (well, I might run it...
Last post
Ha! did I call that one or what! I remember seeing the R.D ent page before a while back, now that I needed it I could not figure it out for the life of me!