This car looks awesome I particularly like the paint job you have achieved. Was it very difficult to out line all the little squares? BTW who makes that chassis is it Raborn?
Dr. Robotnik wrote:This car looks awesome I particularly like the paint job you have achieved. Was it very difficult to out line all the little squares? BTW who makes that chassis is it Raborn?
thanks,all the little squares are vinyl and the lines are striping tape. i do all my own vinyl work. all hand drawn and cut. the chassis is an andys.
This is a work in progress but I have been stashing away bits for this build for a long time now and it's finally starting to come together. I have lots to work out yet. My biggest leap now is finding or making Gold turnbuckles for the project. I've...
Last post
Figuring out where to put the cut for the rear shock tower was the hardest to figure out. when I doo another body I will put it even further back than I did
I ran the hell out of the Ghettoday buggy until the wheels came off literally as it was my fun car I like to bash and pop wheelies with but when the esc burnt out from running thru puddles it was put in the basement for about 2 years now so I...
If you put a modern 2wd buggy from 2022 against a 30-year-old 4wd buggy from 1992 on a medium to high bite clay track who would win this shootout? This is assuming using the same tires and electronics.
Would 30 years of advancements in 2wd...
Last post
I hope the track increased the value of the house. I'd consider that a key feature. 😁. That's a cool layout.
That's funny... he told me a similar storage unit story. He took my card and said he would be in contact. Never heard from him. Heard later that his short term memory is not what it used to be.
At this point I would hope for some vintage paint on...
Ok I give, been trying to figure it out. Looks extremely similar to the Heathen but is clearly different because of namely the reverse facing roof scoop. I know I’ve seen an Andy’s ad Or catalog page with the bodies listed with their parts numbers...
Last post
I think I see 3023 molded into the lexan inside the area I circled.
This is my Andy's Build. Trying to use as much Andy's as I can on this build. Still missing a few pieces.
Last post
Protech IV looks great on there. If you are planning to run it, the wing might get bent kinda easily with the narrow mounting pattern. You could use the outer set of holes to be more stable. For the shelf, it will be just fine.