Re: GoMachV’s 3d printing thread
Posted: Tue Apr 19, 2022 4:56 pm
Not too bad!
RC10Talk - The Net's Largest Vintage R/C Community
GoMachV’s 3d printing thread
Page 8 of 11
Re: GoMachV’s 3d printing thread
Posted: Tue Apr 19, 2022 5:19 pm
Cool! Is the one with the blue tranny the original from Allec and Lane?
Re: GoMachV’s 3d printing thread
Posted: Tue Apr 19, 2022 5:25 pm
Yes that is one of chris’ prototypes
Re: GoMachV’s 3d printing thread
Posted: Tue Apr 19, 2022 11:16 pm
Duuuuuuude….
Sweeeeeeet….
No, seriously though that is sweet !!
Sweeeeeeet….
No, seriously though that is sweet !!
Re: GoMachV’s 3d printing thread
Posted: Wed Apr 20, 2022 3:08 am
Just beautiful , very nicely done .
Re: GoMachV’s 3d printing thread
Posted: Wed Apr 20, 2022 4:13 am
where and how muchRe: GoMachV’s 3d printing thread
Posted: Wed Apr 20, 2022 10:14 am
Not for a while yet
Re: GoMachV’s 3d printing thread
Posted: Wed Apr 20, 2022 10:19 am
A prototype that got raced was sold on eBay (I think by Chris) a few months ago. It was sweet.
.
.
Re: GoMachV’s 3d printing thread
Posted: Wed Apr 20, 2022 10:23 am
Yes, that is the person (Reinaldo) that sent me this one to document
Re: GoMachV’s 3d printing thread
Posted: Wed Apr 20, 2022 11:13 am
The chassis has the square cutout for a gearbox. Which gearbox is that chassis compatible with?
Re: GoMachV’s 3d printing thread
Posted: Wed Apr 20, 2022 11:21 am
It is made for a Lethal Weapon, which sits flat and works without the cutout but with the pocket the belt can breathe a little. Because the chassis was laser cut I couldn’t just take out the small pocket like Chris did in the graphite. The hole will likely be closed in on any production runs, since it isn’t entirely necessary.
Re: GoMachV’s 3d printing thread
Posted: Wed Apr 20, 2022 11:37 am
...trailing arm compatibility would be really cool too
Re: GoMachV’s 3d printing thread
Posted: Wed Apr 20, 2022 11:48 am
Now you are just talking crazyFrankentruck wrote: ↑Wed Apr 20, 2022 11:37 am ...trailing arm compatibility would be really cool too
But don’t think I haven’t thought about it
Re: GoMachV’s 3d printing thread
Posted: Wed Apr 20, 2022 3:59 pm
Looks excellent!!! Coming along very nicely!!!
Are the plastics 3-D printed or machined? They almost look machined, which is why I am asking. Also, for the production run are you planning on anodizing the chassis? Black would look amazing!
Nice work!
-Mark
Re: GoMachV’s 3d printing thread
Posted: Wed Apr 20, 2022 3:59 pm
... seconded!!!Frankentruck wrote: ↑Wed Apr 20, 2022 11:37 am ...trailing arm compatibility would be really cool too
