RC10Talk - The Net's Largest Vintage R/C Community

Amazing! I am going to go broke with this little buggy!

GoMachV wrote: ↑Wed Jun 15, 2022 12:41 pm I just can’t stop. The floodgates have opened.

These are our vintage A&L towers and the Agi Jammer conversion all shrunken

IMHO, the two side body posts are adequate.

Functionally yes, but it just doesn’t look right unless it has that itty bitty body mount stud

Working on the molded chassis at the moment but thought I would toss up the WIP body mounts, I have not modded anything so it is unlikely a screw is going to fit in the adjustable part of the front one... but that is what drill bits are for! Have fun lol

https://cults3d.com/en/3d-model/game/losi-truck-style-body-mounts-for-the-mini-jrx2-work-in-progress

updated chassis pic heh...

Going to do the h-arms after the chassis, although I need to get a set of hinge pins and rear links to make sure I get them right.

clm wrote: ↑Thu Jun 16, 2022 12:24 am Working on the molded chassis at the moment but thought I would toss up the WIP body mounts, I have not modded anything so it is unlikely a screw is going to fit in the adjustable part of the front one... but that is what drill bits are for! Have fun lol

https://cults3d.com/en/3d-model/game/losi-truck-style-body-mounts-for-the-mini-jrx2-work-in-progress

updated chassis pic heh...

Going to do the h-arms after the chassis, although I need to get a set of hinge pins and rear links to make sure I get them right.

Great work!!!

The front kickup has not been sized right and I have not modeled any holes yet but dang if the trans and battery holder did not drop right in! Yes Yes I know I still need to do the bellcrank mounts, this was just a sizing test

There are some mounting holes by the rear bulkhead that got overridden by the longer length of the mini rear bulkhead, I only ever knew these to be used by the RPM esc mount so I will probably slide them forward a bit.

Oh on another note... the junior chassis with no ribbing on top is exactly the same layout as the T and the Pro for the most part.. I bet it would be flimsy but you could do a shelfer lol

Edit#2 the junior chassis is only very slightly different then a LXT/ProSE chassis, trim the sides, extend the tail one hole length..

Nicely done!

Added silver Mini T 2.0 springs. Drained the oil out of the shocks and removed esc for a cleaner look.

Make nylon wheel nuts! Take a regular 4-40 nut, drill center out with a 9/64 bit and thread on.

Those look great. I picked up some 6/32 to use but they still didn’t look quite right. The 4/40 are perfect

Now you need to find some 2mm for the shocks

I got the idea from you and just looked around at what I had..lol

You could always print some nylon nuts if push comes to shove

Decided to go brushed modified like an old school racer...

I like it! Where did you find an open endbell 370?

I have had it for years - nearly tossed it several times. It is the perfect speed too - video footage soon!