RC10Talk - The Net's Largest Vintage R/C Community

Posted: **Sat Aug 08, 2009 7:15 am**

badhoopty wrote:
slotcarrod wrote:
shodog wrote:I'm surprised that no one mentioned dying the plastic parts red.
It would look cool with bright red parts! Stay away from dark red dye and watch the pot as it boils so you get the right red colour!
pull the parts out earlier than you think you should... you may THINK the color is still too light but it will darken as it cools and also over time. you can put them back in if you dont get them dyed good enough.

i think its even in rpms howto.

Thank you I didn't know that.
I will keep that in mind.

Posted: **Sat Aug 08, 2009 10:29 am**

heres the link to rpms howto on dying.

http://www.rpmrcproducts.com/faq/dye.htm

Posted: **Fri Jan 01, 2010 5:20 pm**

Here is a pic of one of mine.
Composite Craft front nose. I forgot what are the special clips to hold the pins??

RC10Talk - The Net's Largest Vintage R/C Community

RC10 HOT TRICK BUILD - BLACK OR WHITE PLASTIC PARTS???

Re: RC10 HOT TRICK BUILD - BLACK OR WHITE PLASTIC PARTS???

Re: RC10 HOT TRICK BUILD - BLACK OR WHITE PLASTIC PARTS???

Re: RC10 HOT TRICK BUILD - BLACK OR WHITE PLASTIC PARTS???