RC10Talk - The Net's Largest Vintage R/C Community

Need I remind you guys, I did build a B2, T2, and my RC10GT(B).

The problem really is, I have more RC10 parts and cars than anything else I have. It is a bit overwhelming as to where to start. Not to mention those parts are not organized by any means. They are just dumped into either RC10 boxes or clear bins, some at home, some at storage.

[quote="mrlexan"]Need I remind you guys, I did build a B2, T2, and my RC10GT(B). quote]

Jay never mind those sill guys just keep building Real RC cars Losi RULES!!!!!!!!

It's all good Jay, sorry for that (too) old bad joke. Didn't mean to offend you of course!

Asso_man! wrote:It's all good Jay, sorry for that (too) old bad joke. Didn't mean to offend you of course!

None taken. I don't bring my feelings (well... most of the time).

FasterLouder wrote:Don't listen to the AE sheeple,come on over to the Dark Side...

come on over to the dark side? hell, he's been over there ever since he showed up.

ok..... ok. i'll stop raggin' on jay about not building an rc10 without a b2, t2, b3, t3, b4, t4, gt, gt2, 10l, 10lss, 10lso, l2, l3, or l4 behind it. it's pretty obvious there's a better chance of me restoring a kyosho before it would ever happen. oops..... i did it again.

ok..... ok. now i'm done.

more more.. you guys are best mates as if it bothers him in the slightest.
feel free to tease me i love it.

karnivool wrote:more more.. you guys are best mates as if it bothers him in the slightest.
feel free to tease me i love it.

He doesn't bother me in the slightest. Scott's the only one that bothers me when he gets on his repro kick. Just kidding.

mrlexan wrote:He doesn't bother me in the slightest.

really? not even a little bit?

i guess i'm gonna have to come up with a new strategy...... institute a whole new offensive. this is just unacceptable.

Ok, with this coming week off and since we are hanging around home, my goal is to get some projects off the table and DONE. So, I need to resurrect this one as I haven't resolved it yet. Pics below and reminder the CVDs are too short. HELP!

i have some cr cvds for sale, i can measure them if ya want

http://www.rc10talk.com/viewtopic.php?f=6&t=12163

Please do.

2.425" from dead center of pin, to dead center of hole on end

2.780" from end to end (ball end with pins is flattened)

those hubs your using are non cr hubs.... that could be your problem

lowrydesign wrote:those hubs your using are non cr hubs.... that could be your problem

I think we have a weinner! I just looked at the hubs and they do pull the CVD out further. I will change them in the a.m. and let you know what I come up with.

Gratzi!

Jay,

Yes the hubs looks to be the XXX's !
Trinity also makes the inner arm mount for the XXX check to be sure about the correct release you used.
In fact the XX Cr inner arm mount was the same than earlier XXX Cr.