RC10Talk - The Net's Largest Vintage R/C Community

I would paint the body black with gold stripes or something,that would be sweet.

Love the car, you did a great job!

V8R wrote:I would paint the body black with gold stripes or something,that would be sweet.

That would be sweet indeed, good tip!!

Thx all for the comments and many thanks to slotcarrod for the help!!

// Torbjörn

Tobbe70 wrote:

V8R wrote:I would paint the body black with gold stripes or something,that would be sweet.

That would be sweet indeed, good tip!!

Thx all for the comments and many thanks to slotcarrod for the help!!

// Torbjörn

Your very welcome, but just one more little thing. The gear cover should be milky not clear. The clear type is a recent Associated replacement part for the B3/B2. B2 and B3 kit gear covers were never clear. If it were just a runner, clear would be great, but you have gone and made a shelf queen, and now you must make it perfect!

It should look like this

Oh gee, this never ends!!
Thx again for the tip and I will keep my eyes open for it! I´ve noticed that this build was more difficult than I thought it would be, finding the parts is pure hell hehe.
I found this dustcover and was mega-happy since it had the same number as it said in the manual but a milky one it shall be!
Many thx again!!
// Torbjörn

looks great. I have been doing similar with an old B3, but my route was almost all used parts slowly building a runner for cheap. I close to finishing soon. I heard a few parts for these are available from Thunder Tiger via the Phoenix BX which is a redone B3.