RC10Talk - The Net's Largest Vintage R/C Community

Never new what those 7060's were for, but now I do. Darn they look good.

What are the chances that they have that same low profile Jason?

a good chance.

i have a set of schumacher mini pins, had them for years and they're used up. but, other than the fronts being narrower than the rears, they're identical. the crps shouldn't be any different.

I'd like to see those , if you can round em up LMK- if they work then I'm in a real bind, because I have an idea of taking a set of 8086's and trimming them to 2.0 to match the stubbie fronts that Al has,( not exactly period correct, but--Flat Stubbie fronts! ) but if the CRP's look like the same outside diameter as my Shuy rears.......then

here's my worn out schumacher cat mini pins......
the fronts that roger has, and the tires in the link i sent you, would look like these. low profile front and rear.

hey my yoke 870c has proline tires on itpro 30 front an rear red compound tires hook up in the loamy stuff i have pics posted here on this site

The only 2.0" tyres that I'll use on the race track are these Losi step pins. They are nice and soft and grip very well on a hard dry track when compared to what else is/was available.

http://cgi.ebay.com/Losi-Rear-2-0-Tires-Step-Pin-Silver-2-/400144410856?pt=Radio_Control_Parts_Accessories

Has the 870C been sorted? I just remembered the tires on my Procat. They look similar to the one on the first post, but the pins are scattered rather than in rows.

The tires on your Pro-Cat is exactly what I ended up with, I had the rears NIP and luckly found the fronts new here