Page 2 of 2
Re: Bump steer
Posted: Tue Feb 15, 2011 6:40 am
by Mr. ED
if that doesn't help enough you need to raise the studs on your A&L rack.
Also adjusting how much the tires lean in during shock compression is affecting the bump steer behaviour. Try putting the upper link a little further outward or downward on your shocktower
Re: Bump steer
Posted: Mon Feb 21, 2011 11:47 pm
by Twiceblown351
OK switch the left to the right. And got rid of all the bump steer. But it will not steer as tight. as stock.
Is it becouse I'm not using inline steering block?
Damn 5600KV mobo max and 2s lipo = back flips at any speed. insane. car jumps like a ase. I love it.
Re: Bump steer
Posted: Tue Feb 22, 2011 12:52 am
by Jay Dub
Well, you can swap the knuckles back, and then raise the inner ball studs on the A&L rack. This should get rid of the bump steer, and get your steering radius back. -Jeff
Re: Bump steer
Posted: Tue Feb 22, 2011 1:47 am
by Twiceblown351
It was allready raise with 2 washers. The problem is the B4 upright king pins are off center. so when there on the right side the axle is to far back. and the steering links are on a back swep angle. and that make for a lot of bump steer.