Page 2 of 2
Re: Ok need help.......please
Posted: Wed Jan 23, 2013 1:48 pm
by moozo
It's all coming back to me now........the timing is well advanced......
Also am I right in thinking the endbell has to go back on the same way it came off.
In other words you can't rotate it 180 degrees.........or can you??
Mick
Re: Ok need help.......please
Posted: Wed Jan 23, 2013 1:58 pm
by jwscab
if it's a standard modified motor, you can put the endbell on backwards, for sure.
Re: Ok need help.......please
Posted: Wed Jan 23, 2013 2:15 pm
by GoMachV
Yup, 180* out only changes the direction of rotation vs the marks on the endbell. Your reversed probably (it will keep you from having to resolder lol) but to get back to 0* draw an imaginary line from the center of 2 of the mounting screws. That line is exactly between the two magnets. That line is 0*. Put the endbell on there and it should run. As far as how advanced from there you should be, I am way too rusty to know
Re: Ok need help.......please
Posted: Wed Jan 23, 2013 3:05 pm
by Charlie don't surf
It's a brushed motor? Endbell has been rotated
pretty common until someone makes that mistake for the first time, after that they never will do it again.