Re: T3 racer
Posted: Sun Sep 15, 2013 11:47 am
I have a T3 basher and only managed to break a rear arm mount. By far my most favorite rc. I now run it mostly on the street with a 5700kv Castle and Pro Line Road Rage tires.
I suggest loctite in all of the rear screws. I managed to loosen multiple screws in one run with heavy Gladiator rear tires that were not perfectly balanced. The screws were not just loose, they backed out multiple turns
Also, I pushed the lipo all the way forward to eliminate wheelies. You shouldn't have a wheelie problem on clay but the forward position may give better balance.
FYI I was barely able to fit a T4 Bulldog body. The stock front body mount makes for a tight fit due to the extreme angle of the hood.
Good luck!
I suggest loctite in all of the rear screws. I managed to loosen multiple screws in one run with heavy Gladiator rear tires that were not perfectly balanced. The screws were not just loose, they backed out multiple turns
Also, I pushed the lipo all the way forward to eliminate wheelies. You shouldn't have a wheelie problem on clay but the forward position may give better balance.FYI I was barely able to fit a T4 Bulldog body. The stock front body mount makes for a tight fit due to the extreme angle of the hood.
Good luck!