Re: trx1 short car
Posted: Mon Mar 23, 2015 5:24 pm
that is sweet. love those dogbones too!
I'm pretty sure the dogbones are oem traxxas...maybe came with a TCP or maybe even TRX3. The outdrives on the trans are made by STRC. I'll try to get you all the part numbers.Lonestar wrote:Very interested in the outdrive/dogbone combo... can you please explain what are these parts and where to source them, please?
Thanks!
Paul
The rear wheels are TRX3 , 2.2 inch. I bought a set of Bandit front wheels that have the same look. Gonna look into aftermarket,bandit style caster block/steering knuckles that have the inboard bearings. If that works I be able to put any current 2.2 front and rear tires on it. the bandit front wheels I bought are either 2.1 or 2.2TRX-1-3 wrote:Lookin' good. Nice paint. Looks aggressive. What are you thinking for tires?
Mark
the dogbones are traxxas. The part #'s are: 4674-single bone, 4670 dogbone kit, drive cup-4673. The drive cups I used are made by STRC....3 sets on eBay right nowLonestar wrote:Very interested in the outdrive/dogbone combo... can you please explain what are these parts and where to source them, please?
Thanks!
Paul
A&L (Mr. Daryl Lane) still puts out dogbone kits for the TRX-1 / 3.OSR wrote:the dogbones are traxxas. The part #'s are: 4674-single bone, 4670 dogbone kit, drive cup-4673. The drive cups I used are made by STRC....3 sets on eBay right nowLonestar wrote:Very interested in the outdrive/dogbone combo... can you please explain what are these parts and where to source them, please?
Thanks!
Paul
OSR wrote:update!
Integy front caster blocks with bandit steering knuckle. The bandit hinge pin that goes through the arm is a smaller diameter than the hole in the arm. Drilled a hole and used a set screw. I have other new old stock arms otherwise I wouldn't have drilled the holes