RC10Talk - The Net's Largest Vintage R/C Community

Posted: **Sat Sep 28, 2019 9:16 am**

I am trying to get my 4-10 legend kit installed and running. Was hoping to use the ten4 bulkheadhead and bearing set up vs cutting mine and sourcing the idler kit.

Any guidance or help on sourcing the ten4 hardware kit would be helpful. I have been trying to connect directly with Brian, but no luck so far. I purchased the bulkhead from Shapeways.

Posted: **Tue Oct 01, 2019 11:43 am**

Mwp1111 wrote: ↑Sat Sep 28, 2019 9:16 am I am trying to get my 4-10 legend kit installed and running. Was hoping to use the ten4 bulkheadhead and bearing set up vs cutting mine and sourcing the idler kit.

Any guidance or help on sourcing the ten4 hardware kit would be helpful. I have been trying to connect directly with Brian, but no luck so far. I purchased the bulkhead from Shapeways.

I responded to your PM. Sorry for the delay, I've been traveling on a very hectic schedule and not keeping up with email and the interwebs.

RC10Talk - The Net's Largest Vintage R/C Community

Ten4 Nose tubes and hardware kit pre-preorder

Re: Ten4 Nose tubes and hardware kit pre-preorder

Re: Ten4 Nose tubes and hardware kit pre-preorder