RC10Talk - The Net's Largest Vintage R/C Community

I like what I'm seeing. The attention to detail is outstanding. Thanks for sharing.

Well it's been awhile, but it's now a roller.

Nice and tidy!
What electronics are you going for?

Very nice. I really dig the work on the back of the chassis/motor plate.

Thanks guys!

sandkil wrote: ↑Mon May 21, 2018 2:11 am What electronics are you going for?

Modern versions of what was in the original. An LRP Flow or SXX esc, Airtronics servo, Reedy S1 (if i race it at the vonats this year) and an Orion lipo.

I like the color change wheels

Apparently, Masami gave him that set of tires to use out of his practice stash.

Couple more pics of the original.

Great work as usual. Lots of cool mods on this one. I hadn't noticed the detail on the nose and wing tubes before.

No huge update on this. But I did find some modern tires that mimic the look of the yoke tires that Mark ran. Proline Slide Jobs.

I enjoy your posts..great stuff. Can you share what attachment (s) you use on your dremel to cut the chassis parts?

Garage Hack wrote: ↑Mon Nov 30, 2020 7:42 am I enjoy your posts..great stuff. Can you share what attachment (s) you use on your dremel to cut the chassis parts?

Thanks. Pretty much lay it out on page 2 of this thread.

https://www.rc10talk.com/viewtopic.php?f=88&t=41123

For someone like me not investigating every detail I’d have never noticed those tires weren’t the same if you didn’t point it out.

scr8p wrote: ↑Wed Jan 09, 2019 11:17 pm No huge update on this. But I did find some modern tires that mimic the look of the yoke tires that Mark ran. Proline Slide Jobs.

Those tires are an uncanny match,very nice!

I had plans of running this car at the vonats this year. But I decided to change the order around a bit. So hopefully the race is still going on in 2025.

But other than getting a body painted and stickered up.... and proper tires for the track surface at the time, it's pretty much ready to go.