Page 2 of 2
Re: - Going back through a TEKIN chassis conversion -
Posted: Sun May 31, 2020 6:04 am
by Asso_man!
Laying down electronics. The ESC turned out great after a good cleaning. Some of the FETs were oxidised and the whole switch was covered with old dried glue. Case was lightly polished.
I added a Futaba receiver too. Still debating soldering the motor wires as it is brand new.
Re: - Going back through a TEKIN chassis conversion -
Posted: Sun May 31, 2020 7:48 am
by winner_evo
Asso_man! wrote: ↑Fri May 29, 2020 1:48 pm
would you remember the specs of that black and gold beaut?
It wears a white dot label with 901 written on it.
Has a Trinity end bell.
The 901 is a 15x2 & 38,000 rpm.
Fantastic build
Re: - Going back through a TEKIN chassis conversion -
Posted: Mon Jun 01, 2020 2:21 pm
by matt1ptkn
Jeff provided a chart in this thread:
https://www.rc10talk.com/viewtopic.php?f=78&t=37938&p=425442&hilit=dymond#p425442 referring to the Gold Label Dymond motors. Just for future reference.
Re: - Going back through a TEKIN chassis conversion -
Posted: Thu Jun 04, 2020 11:10 am
by Asso_man!
Thanks for digging that out! Quite an obscure line of motors.
would you remember the specs of that black and gold beaut?