RC10Talk - The Net's Largest Vintage R/C Community

n20capri wrote: ↑Tue Apr 23, 2024 3:57 pm What's everyone using for a pinion and Motor on their NRC24? I got this kit:
https://www.amazon.com/gp/product/B09HZ82Y1Z/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
And the motor screws DO NOT line up. The pinion I got fit but doesn't have a grub screw - basically just a press fit.

Thanks

looks like it has a 11.8mm bolt circle while the motor I used, Hobbywing 1626, is 12mm. You can probably just open up the bolt hole a little bit to fit it. Yes a good amount of the pinions for these are press fit, which seems to work OK for the power levels.

While my NRC24's electronics were taken for the K24 I still haven't stopped doing stuff to it. Recently it got a fresh body painted up and I made some mini Turbo Scorpion wheels for it to match it's larger sibling. I did notice that the rear track width of this car was a lot narrower than the front, by 10mm, with the original wheels. While this doesn't sound like a lot, it's rather huge when you consider this is a 1/24 scale car. I decided to make lower offset rear wheels to make up this difference. I'll paint them later.