RC10Talk - The Net's Largest Vintage R/C Community

I am not absolutely certain, however the location of the wires would indicate what they are, IMHO. Anything that has to do with controlling the ESC is on the side, anything that has to do with output from the ESC is on the end. I would guess the two red wires being a BEC, the two blacks for the switch, which can be wired together rather than having a switch installed.

I just went out and looked at my Tekin Titan and there are two bundles of wire coming out of the side. One bundle is of three wires - red/white/black - that goes to the receiver. The other bundle is - black/black/ red. The black/black are the switch, the red is a loner that's not hooked up to anything and I believe it to be a BEC. I don't know if I still have the manual running around for it or not, I'll look later.

Dr. Robotnik wrote: Ok and it is for sure, red = FET and black = on/off switch?

I just don't want to muck it up. Thanks a lot.

Confirmed as true.

If this helps...since there should only be one red FET wire (like the other red is for the Rx (+) unless you actually have three small red wires poking out).

Thanks a lot guys I appreciate the help.