Re: SilverTriple's printing and machining stuff...
Posted: Tue Jul 01, 2025 1:25 pm
The centering pin holes where until now guestimates based on my first try...
I did it more methodically this time...
Conclusion of the test with 4mm centering pins:
- 4.01 mm is perfect for the base : it enters but don't move
- 4.02 mm and the pin is sliding perfectly...
- anything more has more play... I could have do my uprights with more precision...
The precision is quite good and this will be used for any of the next parts...
I did it more methodically this time...
Conclusion of the test with 4mm centering pins:
- 4.01 mm is perfect for the base : it enters but don't move
- 4.02 mm and the pin is sliding perfectly...
- anything more has more play... I could have do my uprights with more precision...
The precision is quite good and this will be used for any of the next parts...