RC10Talk - The Net's Largest Vintage R/C Community

scr8p what shocks are those i never seen clear shocks before thats awesome...

Hammad Ghuman (HG) vlt's

The best sealing shocks in the whole world

Charlie don't surf wrote:The best sealing shocks in the whole world

yup.

Sorry, it was hard to resist I just know that other than the green slime on the seals mine will be lucky if they have air in them

Charlie don't surf wrote:The best sealing shocks in the whole world

I think they also were the fastest shocks of its time.

m_vice wrote:I think they also were the fastest shocks of its time.

fastest to be taken off a car and thrown away? yes, most definately.

scr8p wrote:

m_vice wrote:I think they also were the fastest shocks of its time.

fastest to be taken off a car and thrown away? yes, most definately.

Here's my latest design for the rear tower. I'm currently trying to figure out how much these would cost to make because I don't have the go-ahead on the cnc mill I know of.

Well, for a piece of this size the material will cost around $10 per piece. Setup, routing and finishing will run you around another $10 per piece (in the quantities you will be looking at). More than likely there will also be several other charges. So I would be willing to bet, that out the door +/_ $25 USD at a machine shop for anything less than 50 pieces. You might get some places online or in industry who are willing to do it for less. -Jeff

Fiberglass towers are available in the BST section. Thanks -Jeff

When ya gonna have matching fronts

I can make tomorrow if you would like. Long for the B4 shocks?

G10 also?, yes B4 sized fronts. Guess I need to sell some stuff so I can buy more

I don't have enough posts to go into the b/s/t section yet. How can I get one?