RC10Talk - The Net's Largest Vintage R/C Community

Posted: **Sun Apr 27, 2008 10:31 pm**

JK Racing wrote:so the build continues....I have ditched the gold tub chassis in favor a graphite plate chassis, and have started mounting up parts, here it is so far...got super lucky this past weekend, was racing out of town, and the hobby shop had a 50% off table, got the worlds steering set up for $2.50, also picked up 2.2 front & rear rims, and a yellow set of TQ rear wheels (2.0's).

Those look like andys front arms for an ultima, right? A bit too wide, did you try standard ultima front arms also?
I used rc10T arms on the ultima bulks and they fit perfect so the other way round should fit also.

Posted: **Sun Apr 27, 2008 11:21 pm**

Yes, they were, I have proper RPM arms on there now (I dont have any andy's pro chassis arms, or they would be on there).

I got my order from Avid, but ordered the wrong flanged bearings

(front wheel, not rear hub)

So I have another order to send them.

Posted: **Thu Feb 24, 2011 4:00 am**

Hmm... I have 2 "Andy's" 1/12 TOJ (with driver) bodies..one is still NIP and th other is trimmed/mounted not painted.. I wonder if he would spray them on a custom order? This is the body as mounted on my shelf RC12L. The one in the package, sealed is the same.

RC10Talk - The Net's Largest Vintage R/C Community

Next Project...runner/racer

Re: Next Project...runner/racer

Re: Next Project...runner/racer

Re: Next Project...runner/racer