RC10Talk - The Net's Largest Vintage R/C Community

Posted: **Sun Oct 16, 2022 4:49 pm**

@threesheds , I used the data provided to derive something... I'm not sure how close it is from the reality, I'll have to wait I have a real tire in hand to check how much need to be reviewed...

It's quite simple... I may review the stud profile a bit to make them a bit less squared. I believe it still requires work...

Posted: **Sun Oct 16, 2022 5:01 pm**

silvertriple wrote: ↑Sun Oct 16, 2022 4:49 pm @ threesheds , I used the data provided to derive something... I'm not sure how close it is from the reality, I'll have to wait I have a real tire in hand to check how much need to be reviewed...

It's quite simple... I may review the stud profile a bit to make them a bit less squared. I believe it still requires work...

Looks damn close, comparing to a photo maybe dimples or recesses in studs could be smaller. They look oval in a pic and corners of studs a bit rounded but great CAD work.
Maybe some measurements needed to be in parts of a mm. Only a cheap gauge at my disposal.

RC10Talk - The Net's Largest Vintage R/C Community

Hirobo 44B

Re: Hirobo 44B

Re: Hirobo 44B