Page 3 of 3
Re: New Off Topic RC Project - Nickel Plating turnbuckles
Posted: Tue May 27, 2025 8:51 am
by GoMachV
I forget who it was that surface mounted the electronic speed controller into their fiberglass chassis... mid-to-late 80's on-road car... I'm terrible with names.
I remember an on road chassis but can't find the info. Some like the bolink quick change plate used large traces for the battery connection. Then there is this guy, I don't know much of the story but it's pretty cool!
Re: New Off Topic RC Project - Nickel Plating turnbuckles
Posted: Tue May 27, 2025 1:45 pm
by Dangeruss
GoMachV wrote: ↑Tue May 27, 2025 8:51 am
I remember an on road chassis but can't find the info.
At least I'm not the only crazy person that remembers it.
Re: New Off Topic RC Project - Nickel Plating turnbuckles
Posted: Tue May 27, 2025 2:52 pm
by JosephS
That’s a cool implementation. If it wasn’t for the front kickup you could build a whole rc10 this way.
Re: New Off Topic RC Project - Nickel Plating turnbuckles
Posted: Tue May 27, 2025 2:53 pm
by Frankentruck
The RC10DS has no front kickup
Re: New Off Topic RC Project - Nickel Plating turnbuckles
Posted: Tue May 27, 2025 9:32 pm
by JosephS
Frankentruck wrote: ↑Tue May 27, 2025 2:53 pm
The RC10DS has no front kickup
I though it was a small amount like 3-5 degrees?
Re: New Off Topic RC Project - Nickel Plating turnbuckles
Posted: Tue May 27, 2025 10:29 pm
by Charlie don't surf
GoMachV wrote: ↑Tue May 27, 2025 8:51 am
I forget who it was that surface mounted the electronic speed controller into their fiberglass chassis... mid-to-late 80's on-road car... I'm terrible with names.
I remember an on road chassis but can't find the info. Some like the bolink quick change plate used large traces for the battery connection. Then there is this guy, I don't know much of the story but it's pretty cool!
Holy crap that's cool!