RC10Talk - The Net's Largest Vintage R/C Community

Won't do much good to measure the front tires as I made them from a pair of rear Yokomo TR39's. I narrowed them and reduced the diameter. Those Pro-Lines do look like they could be correct. What diameter are the Pro-Lines?

Edit: I found the tires on Ebay and they are the wrong diameter. Eustace was pretty sure they were Yokomo tires, but it was a long time ago. I have been trying to track down Scott Montgomery, but no luck so far.

does anyone know the part number for the shaft that converts the stealth trans to the 4x4 rc10 kit.

the build has really turned out awesome todd. very impressive work.

i would stick with those yokomo tires you have on. i would also hold off on the decals til someone post another closer and clearer picture of the buggy. it would be a waste to cut up perfectly good decals and tires. someone has to have more pictures of the buggy somewhere. it's a matter of time.

hugger19 wrote:does anyone know the part number for the shaft that converts the stealth trans to the 4x4 rc10 kit.

I think it may be posted somewhere back in this thread? I will try to find it. I know that Aaron would know.

littleVETTE wrote:the build has really turned out awesome todd. very impressive work.

i would stick with those yokomo tires you have on. i would also hold off on the decals til someone post another closer and clearer picture of the buggy. it would be a waste to cut up perfectly good decals and tires. someone has to have more pictures of the buggy somewhere. it's a matter of time.

Thank you much Rob. I think that that is great advice!

hugger19 wrote:does anyone know the part number for the shaft that converts the stealth trans to the 4x4 rc10 kit.

http://www.rc10talk.com/viewtopic.php?f=82&t=586

the 410m1 looks great since you rewired it.glad i could help out.Did youfind the novak receiver you needed?don

Thanks Don, the 410 was much appreciated! I have a Novak NER-2S, but it is not an exact match. When time and money allows, I will keep looking for stuff I need.

Thanks,

Todd

Found my receiver and will be on it's way!

UPDATE** I was at home sick today, so I got the Novak receiver installed with fuel tubing and antenna. Also installed Futaba mini servo and made a belt guide out of a RC10 battery cup. The chassis is very close to being finished. What do you guys think? I tried to mimic the magazine photo, but it is not quite there.

Looking awesome Todd. You're holding it with the wrong hand though

Should the antenna mount be screwed to the shock tower?
Looks like you have it on the bulkhead?
Not sure just asking - car looks great.

RC10resto wrote:Should the antenna mount be screwed to the shock tower?
Looks like you have it on the bulkhead?
Not sure just asking - car looks great.

The bulkhead is the original to the car and there was a glue stain on the top where I remounted the antenna base. Not sure how it could be mounted to the shock tower?

romulus22 wrote:Looking awesome Todd. You're holding it with the wrong hand though

I was not holding the car, I was holding the camera, but it appears you might be right!

Vintagemishal wrote:

RC10resto wrote:Should the antenna mount be screwed to the shock tower?
Looks like you have it on the bulkhead?
Not sure just asking - car looks great.

The bulkhead is the original to the car and there was a glue stain on the top where I remounted the antenna base. Not sure how it could be mounted to the shock tower?

looks like a shock tower cap screw is going right thru the side of the antenna mount?