Page 4 of 5
Re: RC10 XXX worlds (FINISHED!)
Posted: Mon Dec 07, 2009 2:56 pm
by slotcarrod
Charlie don't surf wrote:aeiou wrote:Awesome build, Reg! Are those servo mounts RPM parts as well or custom? They look like AE 7336’s, but I can't recall seeing them in white before.
I had a similar experience with RPM parts that were left soaking for a while, except mine turned green. They were in laundry detergent and some bleach and they turned sort of a glow-in-the-dark green. I thought they were ruined, but I built the car anyway. Eventually, they lost most of the green tint and came out looking pretty good.
I bleached a set of team car rear hubs once, and they turned bright yellow! and after about 2 months of sitting they came back--the gear cover is only a touch darker than the new parts and
it should lighten up after a month or so. And the servo mounts are AE 7336's from an early B2-and
I have one more set left for another build
I did not know the early B2 came with white servo mounts, I thought only the servo arms were white. This is great info!
Re: RC10 XXX worlds (FINISHED!)
Posted: Mon Dec 07, 2009 5:34 pm
by Charlie don't surf
I told you a year ago that mine has white bellcranks too
Re: RC10 XXX worlds (FINISHED!)
Posted: Mon Dec 07, 2009 8:09 pm
by ericsp2
so why the rpm tranny? isnt that the gear ratio for the rc10t to except new faster brushless motors?
Re: RC10 XXX worlds (FINISHED!)
Posted: Mon Dec 07, 2009 8:22 pm
by scr8p
probably because it says RPM on it.
not to mention, a rc10b4 buggy has a 2.60 trans. so, it's not like a 2.65 in a buggy is way off base.
Re: RC10 XXX worlds (FINISHED!)
Posted: Tue Dec 08, 2009 1:49 am
by PBR Allstar
Really nice build Reg. Glad the RPM Parts cleaned up nice! Did you end up using the small spring isolators? I didn't know if those were an RPM deal or not, I've never seen that style before, but they were on the shocks so I sent them.
Re: RC10 XXX worlds (FINISHED!)
Posted: Tue Dec 08, 2009 1:58 am
by Charlie don't surf
59burst hooked me up with a Yoke kit with the same isolators and lower spring retainers that were similar to the RPM kit (that I can't seem to find) so I didn't use them, but they are correct for the
quick clips to have that--
Re: RC10 XXX worlds (FINISHED!)
Posted: Tue Dec 08, 2009 8:02 pm
by Mikeyboy
Nice build! Where did you get the idea for the slimmer chassis? Was there a manufacturer who made these?
Re: RC10 XXX worlds (FINISHED!)
Posted: Tue Dec 08, 2009 9:19 pm
by fastang
Mikeyboy wrote:Nice build! Where did you get the idea for the slimmer chassis? Was there a manufacturer who made these?
Associated made them.
Re: RC10 XXX worlds (FINISHED!)
Posted: Tue Dec 08, 2009 9:20 pm
by Mikeyboy
When did they make the worlds chassis? Was it after the worlds car came out?
Re: RC10 XXX worlds (FINISHED!)
Posted: Tue Dec 08, 2009 9:43 pm
by Charlie don't surf
It was the last chassis right before the B2
Re: RC10 XXX worlds (FINISHED!)
Posted: Tue Dec 08, 2009 9:49 pm
by HotRodJosh
Looks GREAT!
But no car is FINISHED until the body is PAINTED.....
Re: RC10 XXX worlds (FINISHED!)
Posted: Tue Dec 08, 2009 9:56 pm
by slotcarrod
Charlie don't surf wrote:I told you a year ago that mine has white bellcranks too
What!!!! You know what to do if you get an extra set right?
If not I will still need pics for the 25 year thread.
Re: RC10 XXX worlds (FINISHED!)
Posted: Wed Dec 09, 2009 8:11 am
by Charlie don't surf
slotcarrod wrote:Charlie don't surf wrote:I told you a year ago that mine has white bellcranks too
What!!!! You know what to do if you get an extra set right?
If not I will still need pics for the 25 year thread.
I took the edinger pics, but haven't edited them yet, and I have to go to PA until Friday--have em' to ya when I get back
Re: RC10 XXX worlds (FINISHED!)
Posted: Wed Dec 09, 2009 9:19 am
by scr8p
reg, are you going to the usow race? i'm not sure if i'll get down there this weekend or not.
Re: RC10 XXX worlds (FINISHED!)
Posted: Thu May 27, 2010 7:46 pm
by Charlie don't surf
Got some parts that I have been looking for
but now that I have installed them I'm not sure
Opinions please!
White
wheels with Yokomo 30 wheels TR31-s and the Pro 105's
1 a1 ae1 001.jpg
1 a1 ae1 002.jpg
Or the way it was with the Yellow wheels, the Pro 88's and the Pro 105's
1 rc10 xxx 003.JPG
HELP