RC10Talk - The Net's Largest Vintage R/C Community

Few updated photos.

Maybe I missed it - what shocks and springs are those?

B5/6 Kashmia with J Concepts collars and caps

Nicely done! Looks awesome.

Very, very, very nice and tidy

I made some finishing touches to the truck. I added the following.

- New 3 piece skinny front wheels and new rears. Dyed black
- New RPM rear bulkhead
- New RPM inner rear arm mounts
- New RPM rear over sized bearing hubs
- New black anodized aluminum chassis screws to replace the yellow/green stock pieces

After I took these photos, I altered the shocks so the Andy's body sits lower on the chassis, and looks correct. I will have to take a few more photos to show it. This thing is now pretty much done. I don't think there is anything more I would want to do to it. In person, it is so cool looking. I wish I could capture that better in the photos.

The site is not allowing me to post the remaining photos. I will try again later.

lavigna wrote: ↑Sat May 13, 2017 12:40 am The site is not allowing me to post the remaining photos. I will try again later.

the story of the new board setup...

Todd

What bellcrank parts are those?

they are probably houge. the factory worlds style bellcranks would be the same roughly speaking. notice they are in the forward position so they are the buggy ones.

EMC wrote: ↑Tue May 16, 2017 12:47 pm What bellcrank parts are those?

They are A&L. Dyed black.

lavigna wrote: ↑Sat May 13, 2017 12:37 am - New 3 piece skinny front wheels and new rears. Dyed black

Tar and feathers!!!

But I have to admit the end-result looks jolly good!!!!

Whoops...my bad. I didn't see the draglink in all the black.

Love the build!

jwscab wrote: ↑Wed May 17, 2017 7:41 am Whoops...my bad. I didn't see the draglink in all the black.

Love the build!

don't feel bad...I studied all the pix after you answered on a decent sized monitor at home and I never seen the draglink in all the black either

Does look good though

Todd

Would have to be my all time favorite 10T build!