<RC10 ver.3>
This RC10 is newly built. The battery is installed in the transverse direction.
For me, this car is best because it turns well, has good rear traction and jump is easy.
I will describe how I set the car which will be answer to Asso_man! and popboy905 (thank you very much for your comments) in next post.
<Front>
・Add 20g weight right by the steering servo
・Front bumper from Shapeway (rapid_rc)
・Extended front shock tower from Fibre Lyte
・V2 big bore shock
・#32.5 oil and white spring and #1.6 piston, outside hole on the arm and middle on the tower
・Shock tower and suspension mounts are tightened with hex nuts
・RC10GT steering bellcrank
・30deg caster block (ASC6210)
・Inline steering block with RC10GT axle (use B4 type front wheel same as the worlds re-re)
・Two shims on the steering block under the ball end
・B4/B44 low profile ball stud is used for the upper linkage on the shock tower side
<Middle>
・Short lipo behind the steering servo and set in the transverse direction
・RC10 battery cups are attached by double sided tape
・ESC is middle of the battery and the rear bulkhead
・Radio receiver is right by the ESC and the capacitor of ESC is placed in other side
・Add the brace from the rear bulkhead to the chassis
<Rear>
・Low profile shock tower for big bore shocks from Carbon works (3mm) and B6 wing mount
・V2 big bore shock from B6 (maybe the longer V2 shock cylinder of B5M/B6.1 might be better to have enough droop)
・#30 oil, #1.6 piston and white spring, outside hole on the arm and the most inside hole on the tower
・Re-re white rear RC10 arm mounts (3 degree toe in) with short wheelbase holes (tightened with hex nuts for all screws)
・B4 FT aluminum hub carriers, 0-degree toe in with axle spacer crush tube
・Vintage stealth transmission case with B4 top shaft
・SC10 rear hex adapter to achieve rear width close to 250mm with modern tires
・Yokomo B-MAX2 CVA shaft where holes are opened up to accommodate RC10 CVA coupler
・Add 2mm shim between the motor plate and chassis
・B4/B44 low profile ball stud is used for the upper linkage on the rear bulkhead side
<Other things>
・B stamp chassis
・Lunsford turnbuckle
・Front width is same as the rear
・I set this car for an indoor clay track
・I have not run this car on a carpet yet