RC10Talk - The Net's Largest Vintage R/C Community

built another one from the leftovers and RPS SE chassis from transamman908
and, I still need the bumper

Very Nice Job Hyeong!! Makes me think i should of kept that chassis
Keep up the good work!!

thanks Eddie. I put the chassis in the box back. and will run after I find the bumper

and enjoy some pics from the rally track

Wow- great build! Thankyou for the extra bit of inspiration. I have been wanting one of these cars for ages and cant wait to get one on the the rece track. Although I'll be running an old stock motor in mine.

I hope you get a nice one Jason
I run with modern tires and 2.2" yoke wheels now. you can see my latest pics here
http://www.rc10talk.com/viewtopic.php?f=39&t=15963&start=0

Bodies look great! Nice paint work.

the original yellow wheels and 870C wheels had deep offset. but newer (larger) wheels don't. I'v been running this 834B runner with 2.2 wheels with modern tires. and put 870C's thick wheel hubs on the rear. and tried to switch left and right front oneway hubs for wide setup. or I could cut the deep offset rear wheels and make them thin. but they didn't see well

and I tried this today. yoke wheel hubs for RC10 and kyosho's looked good to me the back end was gone after drilling with step bit. and got this and they fit well.

Very nice hub mods. Damn now you have me wanting to hold onto and complete me 834.

bormac wrote:Very nice hub mods. Damn now you have me wanting to hold onto and complete me 834.

I'm looking for a few parts for another build too. will contac you soon

got very nice front dogbons made by AYK Race Prep

pargu made this un-practical but beautiful aluminum chassis. I'm not sure if he's gonna produce the chassis or not. made only 2 for me and himself even he doesn't have an 834B.

hey! where is mine very nice job he has done as usual, love the rich colour.

GJW wrote:hey! where is mine very nice job he has done as usual, love the rich colour.

my favorite is black actually. but I tried red and it looks better than expected. the chassis is not complete yet. the counter sink job is not perfect. and few holes should be moved 0.2 to 0.5mm. or maybe the poor counter sink job caused the position problem

Is there a chance these could be cut from black graphite??

Wink-wink.

bormac wrote:Is there a chance these could be cut from black graphite??

Wink-wink.

I measured the dimensions to try a graphite chassis. already put an order for epoxy few weeks ago. and didn't come out yet. will try graphite or woven carbon fiber if the epoxy chassis comes without any issue. my rc buddy who runs an 834b with me draw CAD file for me. and pargu wanted to try with aluminum. will update a few weeks later