RC10Talk - The Net's Largest Vintage R/C Community

Incredible_Serious wrote: Paul,

You mean one of these http://www.tamiyaclub.com/showroom_model.asp?cid=16393&sid=154, and / or one of these http://www.tamiyaclub.com/showroom_model.asp?cid=65316&sid=154?

Or maybe something from here: http://www.tamiyaclub.com/showroom_model.asp?cid=45856&sid=154 ?



Alex

Now you're just teasing I'd forgotten about the Delta Integrale, now that's a cool shell. I had a drive of an Integrale HF Turbo when I was in my 20's (where did they go?) What a car, ludicrously fast.

Paul.

Not today but an accumulation of parts that came in while I was on a trip.

This nice little item arrived today..... not sure whether to use it or install it in a shelfer build....
Oh, wait... I don't have any shelfers!!!!!!

Alex

Incredible_Serious wrote:This nice little item arrived today..... not sure whether to use it or install it in a shelfer build....

Oh, wait... I don't have any shelfers!!!!!!

Alex

There's only one answer then I guess? I think I had a couple of Fantom motors back when I was sponsored by Schumacher - they were distributers for them.... & that looks like a Schuey part sticker?

Talking of Schumachers - I recieved this new (but badly) built Schumacher 99' spec SST for the princely sum of £27 + postage. The 'fuzzy logic' behind me buying it is down to the fact that i needed a few parts for the Axis that I am using as a drifter & wanted to try building some locked diffs for it - so buying this car would actually be cheaper than buying all the new parts from Schumacher (although I could still do with some belts ) The other reason for hitting the BIN buttonis that it also came with the Trinity D3.5 motor which as it happens also looks unused & the packaging is also included This was a motor that I used in my Streetweapon Bitd & would look at home in either the Kinwald XX, XXT G+ or the early XXX buggy that I have?





The car also came with that rather nice Frewer Porsche 911 lexan shell which despite looking un-run has also unfortunately its been sprayed on the outside Question now is what do I do with it - strip for spares or pass it on - perhaps re-build it so that someone from my club could benefit from it?

How about what I didn't get in the post today!
Thought I bought a Playtron Lynx, guess the ebay seller decided not to ship it, no replies to messages, no tracking #.
Ebay sent a refund, but would have rather had the Lynx, just another oddball 4x4.

scootmike wrote:How about what I didn't get in the post today!
Thought I bought a Playtron Lynx, guess the ebay seller decided not to ship it, no replies to messages, no tracking #.
Ebay sent a refund, but would have rather had the Lynx, just another oddball 4x4.

That sucks my friend

Bills

REMJ666 wrote:Bills

I got those today too!

Today was a good day!......


Thanks for the tip off t the eBay auction!

Scored a nice lot of Ti hinge pins- and got lucky! 8 inner front buggy pins- those are the ones I'm always searching for

Can't believe nobody else bid! $20 was a bargain

gomachv wrote:Scored a nice lot of Ti hinge pins- and got lucky! 8 inner front buggy pins- those are the ones I'm always searching for

Can't believe nobody else bid! $20 was a bargain

Oooohhhh..... shiny.......

i got these ( Accumulated ), never run Kit has lotsa hopup ( Team Suzuki /top/etc parts), and spare TS parts, all from fellow members here ( except the Wheels and rims), twas a gift for my Son, but after seeing the condition, I think I may get him another cheapo drift car. its too good to be bashed.



The TS Front Bulkhead was a long shot so I got busted, it will fit but the front kick up Is to low so did not install it.





Side profile.

This showed up last night at my door step. Always wanted one as a kid but for some stupid reason walked out of the hobby shop with something else the day I went to buy it so 20+ years later and after a nice cleaning and a de-smokeing it should go nicely on my shelf.

I got engine bearings for my mini moke... and 3.5mm bullet connectors for the neighbors mini slash lol

Chris

gomachv wrote:Scored a nice lot of Ti hinge pins- and got lucky! 8 inner front buggy pins- those are the ones I'm always searching for

Can't believe nobody else bid! $20 was a bargain

your lucky as ive started looking for ti bits