RC10Talk - The Net's Largest Vintage R/C Community

Mike,
The adapters look sharp. if you PM me your address I can send you a white rear bulkhead cover I have laying around.

Justjoe wrote:Mike,
Do you have all the parts to build the car? have you looked at Podium RC. They list quite a few parts but I have not ordered anything from them yet. I got my TCS shaft from End of the line but they dont have many parts left for the YZ10's.

I wouldn't get too excited by Podium RC. They list stuff they don't have and won't ever be able to get.....You'll order and about 2 months later get an email telling you they can't get hold of your parts. Or in my case, I ordered some YZ10 shells a few years ago not knowing they were rare as hen's teeth, and got sent a load of completely different shells instead!

Any updates on the car?

Not really, I haven't done very much with it in a few weeks. It's hard to spend time in the basement when it's so nice outside. I have sand blasted all the magnesium and aluminum parts. What a pain that was, the only media I had is to large and didn't get all the corners clean. Still looks ok but I will have to do it again when I pick up some smaller media.

Mike,
Any updates on this one...I have been collecting works 91/93 parts to build one from the ground up. Just need the chassis, backbone and rear tower to get one together... I also got some hex drive adapters so I could run the newer six screw wheels.

If your looking for a pair of rear wheels? I have a brand new set in hot pink!

I know I'm reviving old threads but is love to see how these old projects turned out