RC10Talk - The Net's Largest Vintage R/C Community

Ed, have a look here:

https://sdp-si.com/eStore/Direct.asp?GroupID=169

sprockets are listed in the LH column...

I had a look but they aren't metric...

I am confuzzled...how will I measure;

Pitch Circular & Dp?

There is a toggle for metric on the top of the left column...

templeofspeed wrote:There is a toggle for metric on the top of the left column...

Pah! Gah! Nah! Thanks again. I am going back in.

okay I gotcha, CONRAD's page is really set up weird.

Check THIS out.

You need pages 343 and 344. With their chains, you need module 1 gears. Steel might be a bit heavy, but it should work.

Chewbacca wrote:okay I gotcha, CONRAD's page is really set up weird.

Check THIS out.

You need pages 343 and 344. With their chains, you need module 1 gears. Steel might be a bit heavy, but it should work.

I might be mildly retarded but I can only see gears but not chain gears on those pages and a lot of them have modul 1 written next to them.

supposedly their chain works directly with the module 1 gears it's in the text for the chain...

Hey ed,
you could also step down the ration in 2 steps: small gear on the topshaft of the MIP, bigger gear on the outside of your rear construction, smaller gear on the inside of your rear construction and larger pulley upfront. This way your front pulley doesn't have to be twice the size.

anyone know what size a kyosho chain is? Ive been looking for some couple of chains as Im a few short. This might be a cheaper and easier solution

and a great project Doc