RC10Talk - The Net's Largest Vintage R/C Community

X2 on the Marwan Repro OT-30's, they're the one's on my runner Optima and I'm pretty happy with them. I've only run them once though so I can't comment on how long they'll last, depends on the driving surface. I haven't tried the other one's made in Spain(?) yet.

Any chance you'll do a thread of your Optima Project?


Keith

I appreciate the information, sirs. I'll probably order a set from marwanrc then.

Any chance you'll do a thread of your Optima Project?

I've been taking some pictures along the way, so I could make a thread. I just figured my stuff was boring. Seems like everyone has such interesting projects/stories/resto's around here . I'll give it a shot, though.

Optima projects boring? Never! The more the merrier.


Keith

OK, continuing on with Optima Pro-ject, I took the rear gearbox apart to see how it looked inside.



Uploaded with ImageShack.us

Not surprisingly it was a bit grubby, a bonus is the hardened final pinion gear.



Uploaded with ImageShack.us

Rear diff.



Uploaded with ImageShack.us

The right side housing has a gouge in it so I've got another pair of housings on the way, and yes they are the correct housings for the belt drive conversion.



Uploaded with ImageShack.us

Rear diff apart, not that you can see much but all the gears look good enough to re-use.



Uploaded with ImageShack.us

Radio plate for the Pro conversion and alloy bumper brace.



Uploaded with ImageShack.us

I also took the front one-way diff apart, more out of curiosity than anything. This cartrige has a one-way bearing on either side.



Uploaded with ImageShack.us



Uploaded with ImageShack.us



Uploaded with ImageShack.us



Uploaded with ImageShack.us

All 4 axle carriers will be replaced with new one's for obvious reasons.



Uploaded with ImageShack.us

Along with the belt drive gearbox housings I've also ordered a pair of chassis rails.

That's all for now.


Keith